Baying kits
Baying kits allow you to connect multiple racks in your data center. For more information, see HPE Rack baying kit options.
Standard baying kit
The Standard baying kit enables you to connect multiple racks of the same series, height, and depth. To determine which
baying kit to use for your racks, see HPE Rack baying kit options.
Kit contents (P9L12A)
Item Quantity
24-inch baying brackets 4
600-mm baying brackets 4
T-30 Torx screws 9
Required tools
The following tools are required for installation:
T-30 Torx screwdriver
Installing the baying kit
WARNING: To reduce the risk of personal injury or damage to the rack and equipment, position and secure the racks
according to these instructions. Failure to do so could result in an unstable installation.
Procedure
1.
Remove the front and rear doors.
NOTE: The appearance of the rack might vary depending on the model of the rack purchased.
Baying kits 17
To Next Page
Loading...
