7-24
QinQ (Provider Bridging)
Displaying QinQ Config and Status
Displaying the Configuration for a Particular VLAN. This command
uses the VID to identify and display the data for a specific VLAN. Once QinQ
is enabled in mixed vlan mode, an additional field showing the VLAN Type is
added to the display output.
For example:
Figure 7-11. Example of “Show VLAN” for a Specific VLAN (QinQ Enabled)
Syntax: show vlans < vlan-id >
(Changes to parameters when QinQ is enabled:)
VLAN ID: Field name changes from 802.1Q VLAN ID to VLAN
ID only.
Type: In a QinQ enabled environment, the VLAN type can be
either a regular customer VLAN CVLAN, or it can be a tunnel
VLAN in the provider network SVLAN.
HP Switch(config)# show vlan 10
Status and Counters - VLAN Information - Ports - VLAN 10
VLAN ID : 10
Name : Vlan-10
Type : SVLAN
Status : Port-based
Voice : No
Jumbo : No
Port Information Mode Unknown VLAN Status
---------------- --------- ------------- ------
1 Untagged Disable Down
2 Untagged Disable Down
3 Untagged Disable Down
4 Untagged Disable Down
5 Untagged Disable Down
When QinQ is enabled,
the VLAN Type field is
displayed.
To Next Page
Loading...
Need help?
General
