1-22
Static Virtual LANs (VLANs)
Configuring VLANs
creates if you enable GVRP—page 2-1.) Note that each port can be assigned
to multiple VLANs by using VLAN tagging. (See “802.1Q VLAN Tagging” on
page 1-44.)
To Change VLAN Support Settings
This section describes:
■ Changing the maximum number of VLANs to support
■ Changing the Primary VLAN selection (See “Changing the Primary VLAN”
on page 1-37.)
■ Enabling or disabling dynamic VLANs (Refer to chapter 2, “GVRP” .)
1. From the Main Menu select:
2. Switch Configuration
8. VLAN Menu …
1. VLAN Support
You will then see the following screen:
Figure 1-13. The Default VLAN Support Screen
2. Press [E] (for E
dit), then do one or more of the following:
• To change the maximum number of VLANs, type the new number
(1 - 2048 allowed; default 256).
• To designate a different VLAN as the Primary VLAN, select the Primary
VLAN field and use the space bar to select from the existing options.
(Note that the Primary VLAN must be a static, port-based VLAN.)
• To enable or disable dynamic VLANs, select the GVRP Enabled field
and use the Space bar to toggle between options. (For GVRP informa-
tion, refer to chapter 2, “GVRP” .)
To Next Page
Loading...
Need help?
General
