EasyManuals Logo

HP J8697A Advanced Traffic Management Guide

HP J8697A
460 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #81 background imageLoading...
Page #81 background image
1-59
Static Virtual LANs (VLANs)
Special VLAN Types
Components of Voice VLAN Operation
Voice VLAN(s): Configure one or more voice VLANs on the switch. Some
reasons for having multiple voice VLANs include:
Employing telephones with different VLAN requirements
Better control of bandwidth usage
Segregating telephone groups used for different, exclusive purposes
Where multiple voice VLANs exist on the switch, you can use routing to
communicate between telephones on different voice VLANs. .
Tagged/Untagged VLAN Membership: If the appliances using a voice
VLAN transmit tagged VLAN packets, then configure the member ports as
tagged members of the VLAN. Otherwise, configure the ports as untagged
members.
Voice VLAN QoS Prioritizing (Optional)
Without configuring the switch to prioritize voice VLAN traffic, one of the
following conditions applies:
If the ports in a voice VLAN are not tagged members, then the switch
forwards all traffic on that VLAN at “normal” priority.
If the ports in a voice VLAN are tagged members, then the switch forwards
all traffic on that VLAN at whatever priority the traffic has when received
inbound on the switch.
Using the switch’s QoS VLAN-ID (VID) Priority option, you can change the
priority of voice VLAN traffic moving through the switch. If all port member-
ships on the voice VLAN are tagged, the priority level you set for voice VLAN
traffic is carried to the next device. With all ports on the voice VLAN config-
ured as tagged members, you can enforce a QoS priority policy moving
through the switch and through your network. To set a priority on a voice
VLAN, use the following command:
For example, if you configured a voice VLAN with a VID of 10, and wanted the
highest priority for all traffic on this VLAN, you would execute the following
command:
HP Switch(config) # vlan 10 qos priority 7
HP Switch(config) # write memory
Syntax: vlan < vid > qos priority < 0 - 7 >
The qos priority default setting is 0 (normal), with 1 as the
lowest priority and 7 as the highest priority.

Table of Contents

Other manuals for HP J8697A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP J8697A and is the answer not in the manual?

HP J8697A Specifications

General IconGeneral
Ports24
Form FactorRack-mountable
Power SupplyInternal
ManagementManaged
VLAN SupportYes
Jumbo Frame SupportYes
Switching Capacity48 Gbps
Forwarding Rate35.7 Mpps
ModelHP J8697A
Port Type10/100/1000BASE-T
LayerLayer 2

Related product manuals