8-15
Classifier-Based Software Configuration
Traffic Classes
[ icmp-type-number ]
Configures an ICMP packet type as match criteria in a
class configuration by entering its numeric identifier.
Valid values are from 0 to 255.
For information on ICMP packet-type names and numeric
identifiers, go to the Internet Assigned Numbers Authority
(IANA) website at www.iana.com, click on “Protocol Num-
ber Assignment Services”, and then go to the selections
under “Internet Control Message Protocol (ICMP) Param-
eters”.
[ icmpv4-type-name ]
You can also enter any of the following ICMPv4 packet-type
names to configure more precise match criteria for ICMP
packets in an IPv4 class configuration.
To display a list of valid icmpv4-type-name entries when you
enter icmp as the IP protocol type in a match/ignore state-
ment, type ?. Some of the valid values are as follows:
administratively-prohibitednet-tos-unreachable
alternate-addressnet-unreachable
conversion-errornetwork-unknown
dod-host-prohibitedno-room-for-option
dod-net-prohibitedoption-missing
echopacket-too-big
echo-replyparameter-problem
general-parameter-problemport-unreachable
host-isolatedprecedence-unreachable
host-precedence-unreachableprotocol-unreachable
host-redirectreassembly-timeout
host-tos-redirectredirect
host-tos-unreachablerouter-advertisement
host-unknownrouter-solicitation
host-unreachablesource-quench
information-replysource-route-failed
information-requesttime-exceeded
mask-replytimestamp-reply
mask-requesttimestamp-request
mobile-redirecttraceroute
net-redirectttl-exceeded
net-tos-redirectunreachable
To Next Page
Loading...
Need help?
General
