8. Connect the cartridge connectors to the cartridge 1 and 2. You are recommended to wear gloves
and goggles.
9. Tap Finish and check on the front panel.
300 liter cartridge: Swap the material connector
When running out of material on one connector, you can swap it for a full one. Number 1 can be replaced
b
y 3 and 2 by 4.
1. At the processing station’s front panel, tap the Maintenance icon
, then Material > Replace.
2. Disconnect the material cartridge connector from the used material supply.
300 liter cartridge: Swap the material connector 139
To Next Page
Loading...