2. Remove the two spacers. Be careful not to lose them!
3. Pull out the old rubber blade from the two pins at the back, then remove and dispose of it according
to local regulations.
4. Insert the new rubber blade, carefully aligning the two pins at the back.
5. At the front, reinsert and tighten each screw with one hand, while holding the spacer on the other
side with the other hand.
Finish the replacement
1. Push the printhead cleaning material back into place, and close the pinch system (using the black
plastic knob).
2. Close the printhead cleaning roll door and agent door.
3. Turn on the printer.
4. At the front panel, tap the Settings icon
, then Utilities > Maintenance > Replace parts >
Printer reset counter > Reset rubber-blade counter.
246 Chapter 11 Hardware maintenance
To Next Page
Loading...