5. Tap the Settings icon , then System tools > Calibrations > Rubber-blade height adjustment.
See
Rubber-blade height adjustment on page 236 for more details.
Replace a service-station drop-detector module
The following sections provide details for this topic.
Prepare for replacement
The following steps provide the complete procedure for this topic.
1. Ensure that you have the service-station drop-detectors kit.
2. Ensure that the printer is not printing.
3. If a job has just been printed, wait about 20 minutes for the printer to cool down.
4. You are recommended to wear gloves and goggles.
5. Ensure that all windows, covers, and doors are closed and remain in their original positions.
6. Move the print carriage manually to the left to access the capping station.
CAUTION: When moving the print carriage manually, do it slowly, and be careful not to crash it into
an
y other component or the sides of the printer.
7. Turn off the printer.
Replace a service-station drop-detector module
The following steps provide the complete procedure for this topic.
Table 11-21 Warning labels
Risk of burns Crush hazard Risk of trapped
finger
s
Hazardous moving
part
Light radiation
hazard
Electric shock
hazard
For more safety information, see Safety precautions on page 4
Replace a service-station drop-detector module 247
To Next Page
Loading...