9. Align the plates with the line as shown below.
10. Secure the recoating roller with the top four screws.
TIP: Hold the plate up while tightening the top screws.
11. Put back the front lid of the recoating unit, but do not insert the screws yet.
12. Slightly rotate the recoating unit in both directions with your hand, ensuring that the roller gears are
correctly engaged.
CAUTION: Some parts may be damaged if the gears are not correctly engaged when the lid is
clo
sed.
13. Attach the lid with the four T15 screws.
Replace the recoating roller and recoating plates 257
To Next Page
Loading...
