3. Follow strictly the instructions on the front panel. First you will need to remove the F1 or D1 tank and
replace it by a new one. After a while, the front panel will tell you to do the same with the F2 or D2
tank. If necessary, repeat the process with the other pair.
NOTE: Intermediate tanks must be changed in pairs (F1+F2 and D1+D2).
4. Identify the intermediate tanks you have just installed by attaching the appropriate stickers, which
are provided.
5. Put back the side cover and the screws.
6. At the front panel, confirm that tanks have been replaced, so that the refilling process can start.
This may take some time.
Replace the cleaning-roll collector
The following sections provide details for this topic.
Replace the cleaning-roll collector 269
To Next Page
Loading...