11. Tap Continue on the front panel.
IMPORTANT: Do not disconnect the tubes until the cleaning process has finished.
12. Remove the purge tools and place the material collector and material loading nozzle in the parking
position. Tap Continue on the front panel.
13. Clean the sieve. See Clean the sieve on page 278.
Clean the sieve mesh
The following steps provide the complete procedure for this topic.
You may decide to clean the sieve mesh in this way if there is material attached to it that cannot be
r
emoved by the routine sieve cleaning procedure (see
Clean the sieve on page 278).
1. Turn off the processing station.
286 Chapter 11 Hardware maintenance
To Next Page
Loading...