HP Jet Fusion 5200 Series - Page 305

392 pages

To Next Page

To Previous Page

5. Do not touch the filter papers, and always follow the instructions from the manufacturer.

6. Remove the cover locking screws by hand, and open the cover to access the filters.

7. Pull the right-hand filter out of its enclosure.

298 Chapter 11 Hardware maintenance

Main Page

Table of Contents3
Welcome to Your MJF System8
Documentation8
Product Usage Requirements8
MJF Technology9
Usage Recommendations10
Safety Precautions11
Introduction11
General Safety Guidelines11
Final Parts/Builds12
Explosion Hazard13
Electric Shock Hazard15
Heat Hazard16
Fire Hazard16
Mechanical Hazard17
Light Radiation Hazard18
Chemical Hazard18
Ventilation18
Air Conditioning18
Extraction System19
Sound Pressure Level19
Transport19
Build Unit Transport Hazard20
Ergonomic Risk20
3D Part Unpacking21
Personal Protective Equipment21
Use of Tools21
Warnings and Cautions22
Warning Labels22
Emergency Stop Buttons26
Main Components28
Printer28
Processing Station30
Build Unit31
Accessories32
Front Panel33
Status Center35
Beacon35
Change System Options36
Set the Administrator Password37
Software37
HP Smartstream 3D Command Center38
HP Smartstream 3D Build Manager42
Power on and off43
Turn the Printer on and off43
Turn on the Printer for the First Time43
Turn the Printer on and off44
Turn the Processing Station on and off45
Turn on the Processing Station for the First Time45
Turn the Processing Station on and off46
Circuit-Breaker Labels46
Printer and Processing Station Networking48
Connectivity and Remote Monitoring Requirements48
Configuration49
Hostname49
Ipv4 Configuration49
Link Speed50
Troubleshooting50
Link Issues50
Restore Factory Settings50
Prepare a File for Printing51
Introduction51
File Preparation51
Tessellation51
Load Material into the Build Unit56
Loading Procedure56
Change to a Different Type of Material61
Grade 1: Light Cleaning62
Grade 2: Deep Cleaning and Material Purge62
Grade 3: Full Deep Clean63
Purge the Processing Station63
Empty the Material from the Build Unit67
Check and Clean the Interior of the Build Unit75
Print78
Job List App78
Send a Job to be Printed78
Delay Printing78
Select a Job to be Printed79
Add Job While Printing80
Cancel a Job81
Check Status on the Front Panel82
Check Status Remotely83
Possible Errors While Printing83
Print Modes83
Unpack the Build84
General Advice and Precautions84
If the Forklift Does Not Fit84
Sheet-Metal Installation Process85
Calibration Process88
Extracting the Build to the Natural Cooling Unit91
Unpacking with the Natural Cooling Unit95
Unpacking Without the Natural Cooling Unit95
Part Cleaning and Postprocessing103
Hardware Maintenance104
Safety Precautions104
General Cleaning Instructions104
Maintenance Resources105
Maintenance Kits105
Kit Contents and Recommended Tools105
Preventive Maintenance111
Preventive Maintenance Alerts and Actions111
Consumables114
Printer114
Processing Station139
How to Recycle Supplies154
Printer Maintenance154
Summary of Maintenance Operations154
Maintenance Operations158
Processing-Station Maintenance283
Summary of Maintenance Operations283
Quick Graphical Reminders of Frequent Operations284
Maintenance Operations285
Build-Unit Maintenance313
Summary of Maintenance Operations313
Quick Graphical Reminders of Frequent Operations314
Maintenance Operations314
Move or Store the Product331

HP Jet Fusion 5200 Series - Page 305

Table of Contents

Related product manuals