If the problem persists after fixing the connection, it is also possible that the primer itself is broken. In
this case, replace the corresponding primer. See Replace a primer on page 229.
0085-0013-0X33 Carriage – Primer – Current too high
Where X is:
1. Primer on Printhead 1
2. Primer on Printhead 2
3. Primer on Printhead 3
The primer is broken. Replace the corresponding primer. See Replace a primer on page 229.
0085-0013-0X41 Carriage – Primer – Leakage
Where X is:
1. Primer on Printhead 1
2. Primer on Printhead 2
3. Primer on Printhead 3
There is a leak in the primer air circuit. The most probable cause is that the primer ports were wrongly
inser
ted when latching the printhead. Re-latch the corresponding printhead.
The primer ports are two small air ports below the latch that must fit into the two top printhead holes.
See Replace a printhead on page 113, steps 5 and 6 to release and lift the latch, step 12 and 13 to ensure
primer por
ts are well inserted, and step 14 to close it.
IMPORTANT: Just lift the latch and close it; do not extract the printhead.
If the problem persists after re-latching the printhead, it is also possible that the primer ports are broken
or the primer cir
cuit itself leaks. In this case, replace the corresponding primer. See
Replace a primer on
page 229.
0085-0013-0X33 Carriage – Primer – Current too high 381
To Next Page
Loading...