Troubleshooting
Solving Problems
1-67
If a PCI accessory board is not recognized by the Omnibook
• Make sure the drivers for the PCI accessory board are installed. See the
instructions provided with your PCI board.
If the SCSI device in the PC device bay is not working properly
• Check that the SCSI, power 1, and audio 1 (if required) cables are securely
connected to the device. .
• Make sure the device has proper SCSI termination.
• If SCSI devices are connected to the SCSI port on the rear of the dock, make
sure all devices are turned on and only the last device on the bus is terminated.
• Make sure all SCSI devices have a unique SCSI address from 0 to 6. Refer to the
installation guide provided with the device for information on selecting a SCSI
address.
If SCSI devices connected to the SCSI port are not working properly
• Make sure all devices are turned on and the last device on the bus is
terminated.
• Check that SCSI interface cables are securely attached.
• If devices are daisy-chained, make that no devices in the middle of the chain
are terminated.
• Make sure that all SCSI devices are turned on before starting your OmniBook.
• Make sure all SCSI devices have a unique SCSI address from 0 to 6. Refer to the
installation guide provided with the device for information on selecting a SCSI
address.
If the IDE device in the PC device bay is not working
• Check that the IDE cable, power, and audio (if required) cables are securely
connected. .
• Make sure the IDE device is set to “Master”. If it still does not work, try the
“Cable Select” or “CSEL” setting. Refer to the installation guide provided with
the device for information on setting Master/Slave/Cable Select options.
To Next Page
Loading...
Need help?
General