HP ProCurve 6120G/XG

Web and MAC Authentication
Configuring MAC Authentication on the Switch
Configuring a MAC-based Address Format
Syntax: aaa port-access mac-based addr-format <no-delimiter | single-dash |
multi-dash | multi-colon | no-delimiter-uppercase | single-dash-
uppercase | multi-dash-uppercase | multi-colon-uppercase>
Specifies the MAC address format to be used in the RADIUS
request message. This format must match the format used
to store the MAC addresses in the RADIUS server. (Default:
no-delimiter)
no-delimiter — specifies an aabbccddeeff format.
single-dash — specifies an aabbcc-ddeeff format.
multi-dash — specifies an aa-bb-cc-dd-ee-ff format.
multi-colon — specifies an aa:bb:cc:dd:ee:ff format.
no-delimiter-uppercase — specifies an AABBCCDDEEFF
format.
single-dash-uppercase — specifies an AABBCC-DDEEFF
format
multi-dash-uppercase — specifies an AA-BB-CC-DD-EE-FF
format
multi-colon-uppercase — specifies an AA:BB:CC:DD:EE:FF
format.
Syntax: [no] aaa port-access mac-based < port-list >
Enables MAC-based authentication on the specified
ports. Use the no form of the command to disable MAC-
based authentication on the specified ports.
Syntax: aaa port-access mac-based [e] < port-list > [addr-limit <1-32>]
Specifies the maximum number of authenticated
MACs to allow on the port. (Default: 1)
Note: On switches where MAC Auth and 802.1X can
operate concurrently, this limit includes the total
number of clients authenticated through both methods.
3-53