RADIUS Authentication, Authorization, and Accounting
Using SNMP To View and Configure Switch Authentication Features
Changing and Viewing the SNMP Access Configuration
Syntax: snmp-server mib hpswitchauthmib < excluded | included >
included: Enables manager-level SNMP read/write access to the
switch’s authentication configuration (hpSwitchAuth) MIB.
excluded: Disables manager-level SNMP read/write access to the
switch’s authentication configuration (hpSwitchAuth) MIB.
(Default: included )
Syntax: show snmp-server
The output for this command has been enhanced to display the
current access status of the switch’s authentication configuration
MIB in the Excluded MIBs field.
For example, to disable SNMP access to the switch’s authentication MIB and
then display the result in the Excluded MIB field, you would execute the
following two commands.
ProCurve(config)# snmp-server mib hpswitchauthmib excluded
ProCurve(config)# show snmp-server
SNMP Communities
Community Name MIB View Write Access
---------------- -------- ------------
public Manager Unrestricted
Trap Receivers
Link-Change Traps Enabled on Ports [All] : All
Send Authentication Traps [No] : No
Address Community Events Sent in Trap
---------------------- ---------------- -------------------
Excluded MIBs
hpSwitchAuthenticationMIB
This command disables
SNMP security MIB
access.
Indicates that SNMP security MIB
access is disabled, which is the
nondefault setting.
To Next Page
Loading...
Need help?
General