HP ProCurve 6120G/XG

Configuring Advanced Threat Protection
DHCP Snooping
ProCurve(config)# show dhcp-snooping stats
Packet type Action Reason Count
----------- ------- ---------------------------- ---------
server forward from trusted port 8
client forward to trusted port 8
server drop received on untrusted port 2
server drop unauthorized server 0
client drop destination on untrusted port 0
client drop untrusted option 82 field 0
client drop bad DHCP release request 0
client drop failed verify MAC check 0
Figure 10-2. Example of Show DHCP Snooping Statistics
Enabling DHCP Snooping on VLANS
DHCP snooping on VLANs is disabled by default. To enable DHCP snooping
on a VLAN or range of VLANs enter this command:
ProCurve(config)# dhcp-snooping vlan <vlan-id-range>
You can also use this command in the vlan context, in which case you cannot
enter a range of VLANs for snooping.
Below is an example of DHCP snooping enabled on VLAN 4.
ProCurve(config)# dhcp-snooping vlan 4
ProCurve(config)# show dhcp-snooping
DHCP Snooping Information
DHCP Snooping : Yes
Enabled Vlans : 4
Verify MAC : Yes
Option 82 untrusted policy : drop
Option 82 Insertion : Yes
Option 82 remote-id : mac
Figure 10-3. Example of DCHP Snooping on a VLAN
10-7