HP ProCurve 6120G/XG User Manual

RADIUS Authentication, Authorization, and Accounting
Configuring the Switch for RADIUS Authentication
2. Add a RADIUS server with an IP address of 10.33.18.119 and a server-
specific encryption key of “source0119”.
Figure 5-4. Sample Configuration for RADIUS Server Before Changing the Key and
Adding Another Server
To make the changes listed prior to figure 5-4, you would do the following:
Changes the key
for the existing
server to
“source0127”
(step 1, above).
Adds the new
RADIUS server
with its required
“source0119” key.
Lists the switch’s
new RADIUS
server
configuration.
Compare this with
Figure 5-5. Sample Configuration for RADIUS Server After Changing the Key and Adding Another Server
To change the order in which the switch accesses RADIUS servers, refer to
“Changing RADIUS-Server Access Order” on page 5-60.
4. Configure the Switch’s Global RADIUS Parameters
You can configure the switch for the following global RADIUS parameters:
5-17

HP ProCurve 6120G/XG Specifications

General

Brand	HP
Model	ProCurve 6120G/XG
Category	Switch
Language	English