Configuring Secure Socket Layer (SSL)
Configuring the Switch for SSL Operation
Configuring the Switch for SSL
Operation
SSL-Related CLI Commands in This Section Page
web-management ssl page 8-19
show config page 8-19
show crypto host-cert page 8-12
crypto key
generate cert [rsa] <512 | 768 |1024> page 8-10
zeroize cert page 8-10
crypto host-cert
generate self-signed [arg-list] page 8-10
zeroize page 8-10
1. Assigning a Local Login (Operator) and
Enabling (Manager) Password
At a minimum, ProCurve recommends that you always assign at least a
Manager password to the switch. Otherwise, under some circumstances,
anyone with Telnet, web, or serial port access could modify the switch’s
configuration.
Using the web browser interface To Configure Local Passwords. You
can configure both the Operator and Manager password on one screen. To
access the web browser interface, refer to the chapter titled “Using the
ProCurve Web Browser Interface” in the Management and Configuration
Guide for your switch.
8-7
To Next Page
Loading...
Need help?
General