Configuring Advanced Threat Protection
Dynamic ARP Protection
ProCurve(config)# show arp-protect
ARP Protection Information
Enabled Vlans : 1-4094
Validate : dst-mac, src-mac
Port Trust
B1 Yes
B2 Yes
B3 No
B4 No
B5 No
Figure 10-1. The show arp-protect Command
Displaying ARP Packet Statistics
To display statistics about forwarded ARP packets, dropped ARP packets,
MAC validation failure, and IP validation failures, enter the show arp-protect
statistics command:
ProCurve(config)# show arp-protect statistics
Status and Counters - ARP Protection Counters for VLAN 1
Forwarded pkts : 10 Bad source mac : 2
Bad bindings : 1 Bad destination mac: 1
Malformed pkts : 0 Bad IP address : 0
Status and Counters - ARP Protection Counters for VLAN 2
Forwarded pkts : 1 Bad source mac : 1
Bad bindings : 1 Bad destination mac: 1
Malformed pkts : 1 Bad IP address : 1
Figure 10-2. Show arp-protect statistics Command
10-22
To Next Page
Loading...
Need help?
General