Security Overview
Getting Started with Access Security
2. When you enter the wizard, you have the following options:
• To update a setting, type in a new value, or press [Enter] to keep the
current value.
• To quit the wizard without saving any changes, press [CTRL-C] at any
time.
• To access online Help for any option, press [?].
After you have gone through each setup option, the wizard displays the
summary configuration together with a prompt to save the changes (see
Figure 1-1 on page 1-11 for an example).
3. When the message appears asking if you want to save these changes, you
have the following options:
• To save your changes, press [Enter].
• To cancel any changes without saving, type [n] and then press [Enter].
After pressing [Enter], the wizard exits to the command line prompt.
CLI Wizard: Operating Notes and Restrictions.
â– Once a password has been configured on the switch, you cannot remove
it using the CLI wizard. Passwords can be removed by executing the no
password command directly from the CLI.
â– When you restrict SNMP access to SNMPv3 only, the options SNMPv2
community name and access level will not appear.
â– The wizard displays the first available SNMPv2 community and allows the
user to modify the first community access parameters.
â– The wizard creates a new SNMP community only when no communities
have been configured on the switch.
Web: Management Interface Wizard
To use the Management Interface wizard from the Web browser interface,
follow the steps below:
1. Click the Security tab.
2. Click the Setup Wizard button.
1-12
To Next Page
Loading...
Need help?
General