ProCurve(config)# show filter
Traffic/Security Filters
Indicates the port number or port-
IDX Filter Type | Value
trunk name of the source port or trunk
--- ------------ + -------------------
assigned to the filter.
1 Source Port | 2
2 Source Port | 3
An automatically assigned index
3 Source Port | 4
number used to identify the filter for
4 Source Port | 5
a detailed information listing. A filter
5 Source Port | 6
retains its assigned IDX number for
6 Source Port | 8
as long as the filter exists in the
switch. The switch assigns the
7 Source Port | 9
lowest available IDX number to a new
8 Source Port | 12
filter. This can result in a newer filter
having a lower IDX number than an
20 Source Port | 24
older filter if a previous (source-port
21 Source Port | 25
or named source-port) filter deletion
created a gap in the filter listing.
22 Source Port | 26
23 Source Port | 7
24 Source Port | 10
25 Source Port | 11
26 Source Port | 1
Figure 11-7. Example of the show filter Command
Using the IDX value in the show filter command, we can see how traffic is
filtered on a specific port (Value).The two outputs below show a non-
accounting and an accounting switch port.
11-11
To Next Page
Loading...
Need help?
General