HP ProCurve 6120G/XG

shared secret key, saving to configuration
file … 2-11, 2-15
show accounting … 5-59
show authentication … 5-58
SNMP access security not supported … 5-4
SNMP access to auth config MIB … 5-4
statistics, viewing … 5-56
terminology…5-5
TLS … 5-6
Tunnel-Type attribute … 5-44
vendor specific attributes … 5-45
vendor-specific attributes … 5-37, 6-4
VSAs … 5-38
web browser security not supported … 5-7
web-browser access controls … 5-34
web-browser security not supported … 5-4, 5-34
RADIUS-assigned ACLs …6-9
802.1X port-based access … 6-17
802.1X user-based access … 6-17
ACE, defined … 6-9
application type … 6-10
contrasting dynamic and static … 6-13
DA, defined … 6-10
defined … 6-9
definitions … 6-9
deny any, implicit, switched packets … 6-16
deny, defined … 6-10
dynamic port ACL … 6-10
dynamic port ACL, effect … 6-17
filters … 6-13
implicit deny, defined … 6-10
inbound traffic, defined … 6-10
inverse mask
See wildcard.
mask … 6-10
mask, defined … 6-10
multiple application types in use … 6-15
multiple clients, access restriction … 6-17
multiple dynamic ACLs … 6-17
outbound traffic, defined … 6-10
permit, defined … 6-11
resource monitor … 6-30
See also ACLs.
source routing, caution … 6-14
standard attribute … 6-18
static-port ACL … 6-11
switched packets … 6-16
terminology…6-9
terms … 6-9
vendor-specific attribute … 6-18
wildcard … 6-10, 6-11
wildcard, defined … 6-11
rate-limit
override … 12-63
rate-limiting … 10-34
RADIUS administered … 5-4
RADIUS override … 6-7
RADIUS server specified … 6-6
RADIUS server support … 6-4
RADIUS-assigned vs. applied … 6-5
RADIUS-assigned, increments … 6-5
remote-id
changing … 10-11
snooping … 10-10
reserved port numbers … 7-19, 8-20
Reset-on-clear
disabled when saving security credentials to
configuration file … 2-20
RFCs
RFC 2548 … 5-45
RFC 3580 … 5-44
RFC 4675 … 5-44
routing
source-routing, caution … 6-14, 9-12, 9-33
RSA key, cert …7-11
S
security
authorized IP managers … 14-1
per port … 13-3
security credentials
802.1X credentials saved to configuration
file … 2-14, 2-21
copying configurations on the switch … 2-20
copying startup configuration … 2-19
disabling Reset-on-clear option … 2-20
downloading a configuration file … 2-19
downloading from a server … 2-10
enabling storage in configuration file … 2-11
manager username and password … 2-12
operator username and password … 2-12
RADIUS … 2-15
saving to running configuration with include-
credentials … 2-19
saving to startup configuration … 2-19
Index – 11