Memory
Description
16-GB, PC4-17000
8-GB, PC4-17000
4-GB, PC4-17000
The computer comes with double data rate 3 synchronous dynamic random access memory (DDR4-SDRAM)
dual inline memory modules (DIMMs).
DIMMs
(ProDesk 400 and 480 models) The memory sockets on the system board can be populated with up to two
industry-standard DIMMs. These memory sockets are populated with at least one preinstalled DIMM. To
achieve the maximum memory support, you can populate the system board with up to 32-GB of memory
congured in a high-performing dual channel mode.
(ProDesk 490 models) The memory sockets on the system board can be populated with up to four industry-
standard DIMMs. These memory sockets are populated with at least one preinstalled DIMM. To achieve the
maximum memory support, you can populate the system board with up to 64-GB of memory congured in a
high-performing dual channel mode.
DDR4-SDRAM DIMMs
For proper system operation, the DIMMs must be:
●
industry-standard 288-pin
●
unbuered non-ECC PC4-17000 DDR4-2133 MHz-compliant
●
1.2 volt DDR4-SDRAM DIMMs
The DIMMs must also:
●
support CAS latency 15 DDR4 2133 MHz (15-15-15 timing)
●
contain the mandatory JEDEC SPD information
In addition, the computer supports:
●
512-Mbit, 1-Gbit, and 2-Gbit non-ECC memory technologies
●
single-sided and double-sided DIMMs
●
DIMMs constructed with x8 and x16 DDR devices; DIMMs constructed with x4 SDRAM are not supported
NOTE: The system will not operate properly if you install unsupported DIMMs.
Memory 27
To Next Page
Loading...
Need help?
General
