To Next Page

To Previous Page

Fan sink

Description

Fan sink, standard

Fan sink, BFR/PVC free

WARNING! To reduce risk of personal injury from hot surfaces, allow the internal system components to

cool before touching.

NOTE: System board appearance may vary.

1. Prepare the computer for disassembly (Preparation for disassembly on page 23).

2. Remove the access panel (Access panel on page 24).

3. Disconnect the fan cable from the system board connector labeled CPUFAN (1), and then loosen the four

captive Torx T15 screws (2) that secure the fan sink to the system board.

CAUTION: Remove fan sink retaining screws in diagonally opposite pairs (as in an X) to even the

downward forces on the processor.

4. Lift the fan sink from atop the processor.

CAUTION: Fan sink retaining screws should be tightened in diagonally opposite pairs (as in an X) to evenly

seat the heat sink on the processor.

56 Chapter 4 Removal and replacement procedures: Microtower

Other manuals for HP ProDesk 490 G3 MT

Questions and Answers:

Need help?

Do you have a question about the HP ProDesk 490 G3 MT and is the answer not in the manual?

General