To Next Page

To Previous Page

Table 5-3 Computer Setup—Advanced (for advanced users) (continued)

S0 (On) = Solid white LED.

S3 (Stand By)= 3 blinks at 1Hz (50% duty cycle) followed by a pause of 2 seconds (white LED) — repeated

cycles of 3 blinks and a pause.

S4 (Hibernation)= 4 blinks at 1Hz (50% duty cycle) followed by a pause of 2 seconds (white LED) —

repeated cycles of 4 blinks and a pause.

S5 (Soft O) = LED is o.

Power On from Keyboard Ports (enable/disable)

When enabled, this feature allows a key press to power on the system when it is o (S5 state). If using a

USB keyboard, it must be plugged into one of the rear ports labeled with the keyboard icon. Default is

disabled.

Remote Management

Options

USB Key Provisioning Support (enable/disable) Default is disabled.

USB Redirection Support (enable/disable). Default is enabled.

USB redirection allows USB devices plugged into a client computer to be transparently redirected to the

guest operating system.

SOL Terminal Emulation Mode (ANSI / VT100). Default is ANSI.

SOL terminal emulation mode is only activated during remote AMT redirection operations. The emulation

options allow administrators to select which mode works best with their console.

Show Uncongure ME Conrmation Prompt (enable/disable). Default is enabled.

Verbose Boot Messages (enable/disable). Default is enabled.

Verbose boot shows additional logging information during the boot. mainly for debugging if something

goes wrong during bootup.

Watchdog Timer (enable/disable). Default is enabled.

Allows you to set amount of time for a operating system and BIOS watchdog alert to be sent if the timers

are not deactivated. BIOS watchdog is deactivated by BIOS and would indicate that a halt occurred during

execution if the alert is sent to the management console. An operating system alert is deactivated by the

operating system image and would indicate that a hang occurred during its initialization.

●

OS Watchdog Timer (min.) – (5/10/15/20/25). Default is 5 min.

●

BIOS Watchdog Timer (min.) – (5/10/15/20/25). Default is 5 min.

CIRA Timeout (min.) (1/2/3/4/Never)

CIRA is Customer Initiated Remote Assistance, an Intel service to help users employing Active

Management Technology (AMT).

Computer Setup (F10) Utilities 77

Other manuals for HP ProDesk 490 G3 MT

Questions and Answers:

Need help?

Do you have a question about the HP ProDesk 490 G3 MT and is the answer not in the manual?

General