HP ProLiant BL30p

Index
replacing battery C-3
server blades
requirements, local I/O cable 6-1
deployment methods 5-26
RFI/EMI connector hoods C-2
diagnostic steps A-5
ROM
installing 3-4
flashing See remote ROM flash
LEDs 1-4
redundant See redundant ROM
ROMs 5-6
support 5-5
troubleshooting A-2
ROM-Based Setup Utility (RBSU) 5-7
settings
default settings 5-8
ROM-Based Setup Utility (RBSU) 5-8
definition 5-7
System Maintenance Switch (SW1) 1-6
navigating 5-8
shielded cables C-2
ROM-Based Setup Utility (RBSU), iLO 5-4
Smart Components for Remote ROM
Flash 5-6
ROMPaq Utility 5-7
ROMs
SmartStart Scripting Toolkit 5-28
iLO 5-6
software
power management module 5-6
Automatic Server Recovery-2 5-15
server blade management module 5-6
Diagnostics Utility 5-14
server blade system 5-6
HP ProLiant Essentials Rapid
Deployment Pack (RDP) 5-27
HP Systems Insight Management (HP
SIM) 5-14
S
safety product C-2
ROMPaq Utility 5-7
SAN 5-32, 5-33
static electricity D-1
server blade
static IP bay configuration 5-19
cautions 3-1
advanced configuration parameters 5-23
components 1-1
configuring server blade enclosure 5-20
configuring using SmartStart 6-6
definition 5-19
connecting USB devices 6-4
iLO firmware requirements 5-20
connecting video devices 6-4
iLO hardware requirements 5-20
connecting with local I/O cable 6-5, 6-6
iLO IP address assignment 5-24
directly accessing 6-5, 6-6
remote insight command language 5-24
loading updates 6-6
standard configuration parameters 5-23
powering down 2-2
user requirements 5-20
release buttons 3-6
static IP bay settings, configuring 5-21
removing 3-6
static-dissipating work mat D-2
warnings 3-1
static-sensitive devices D-1
server blade blanks
straps
airflow 3-2, 3-4
bootstraps D-2
storing 3-3
heel D-2
server blade enclosure, configuring 5-20
toe D-2
server blade management modules, ROM
flashing 5-6
wrist D-2
supported operating systems 5-31
Survey Utility 5-16
HP ProLiant Typhoon Server Blade Setup and Installation Guide Index-5