To Next Page

To Previous Page

Removal and replacement procedures 30

To replace the component, reverse the removal procedure.

Hard drive

IMPORTANT: Hot-plug capability and drive LED support are only available when a supported

optional controller is installed in the server.

To remove the component:

1. Back up all data on the hard drive.

2. Power down the server (on page 27).

CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless

all bays are populated with either a component or a blank.

3. Remove the hard drive.

Other manuals for HP ProLiant DL320 Generation 5p

Questions and Answers:

Need help?

Do you have a question about the HP ProLiant DL320 Generation 5p and is the answer not in the manual?

General

Processor Sockets	1
Memory Slots	4
Storage	SATA or SAS
Form Factor	1U rackmount
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server
Processor	Intel Xeon 3000, 3200 series
Memory	Up to 8GB DDR2
Drive Bays	2 x 3.5" Non-hot plug SATA or SAS
Expansion Slots	1 PCI-Express x8, 1 PCI-Express x4