EasyManuals Logo

HP ProLiant DL320 Generation 5p Maintenance And Service Guide

HP ProLiant DL320 Generation 5p
85 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #60 background imageLoading...
Page #60 background image
Diagnostic tools 60
Array Diagnostic Utility
The HP Array Diagnostics Utility is a web-based application that creates a report of all HP storage
controllers and disk drives. This report provides vital information to assist in identifying faults or conditions
that may require attention. ADU can be accessed from the SmartStart CD or downloaded from the HP
website (http://www.hp.com
).
HP Systems Insight Manager
HP SIM is a web-based application that allows system administrators to accomplish normal administrative
tasks from any remote location, using a web browser. HP SIM provides device management capabilities
that consolidate and integrate management data from HP and third-party devices.
IMPORTANT: You must install and use HP SIM to benefit from the Pre-Failure Warranty for
processors, SAS and SATA hard drives, and memory modules.
For additional information, refer to the Management CD in the HP ProLiant Essentials Foundation Pack or
the HP SIM website (http://www.hp.com/go/hpsim
).
USB support and functionality
USB support (on page 60)
Internal USB functionality (on page 60)
USB support
HP provides both standard USB support and legacy USB support. Standard support is provided by the
operating system through the appropriate USB device drivers. HP provides support for USB devices before
the operating system loads through legacy USB support, which is enabled by default in the system ROM.
HP hardware supports USB version 1.1 or 2.0, depending on the version of the hardware.
Legacy USB support provides USB functionality in environments where USB support is normally not
available. Specifically, HP provides legacy USB functionality for:
POST
RBSU
Diagnostics
DOS
Operating environments which do not provide native USB support
For more information on ProLiant USB support, refer to the HP website
(http://h18004.www1.hp.com/products/servers/platforms/usb-support.html
).
Internal USB functionality
An internal USB connector is available for use with USB drive keys only. The internal connector shares the
same bus with the front external USB connector, and connecting a device to both the front internal and
front external USB connectors is not supported. This solution provides for use of a permanent boot drive

Table of Contents

Other manuals for HP ProLiant DL320 Generation 5p

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProLiant DL320 Generation 5p and is the answer not in the manual?

HP ProLiant DL320 Generation 5p Specifications

General IconGeneral
Processor Sockets1
Memory Slots4
StorageSATA or SAS
Form Factor1U rackmount
Operating System SupportMicrosoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server
ProcessorIntel Xeon 3000, 3200 series
MemoryUp to 8GB DDR2
Drive Bays2 x 3.5" Non-hot plug SATA or SAS
Expansion Slots1 PCI-Express x8, 1 PCI-Express x4

Related product manuals