Component identification 17
PCIe 3-slot riser cage PCIe 2-slot x16 riser cage*
1 - 3/4L/FH
PCIe3 x16 (16, 8,4,2,1)**
*The server ships with one PCIe3 riser cage installed in the primary riser cage connector.
**The x16 PCIe3 riser cage is optional and can be converted to a FH riser. This conversion requires a
second processor to be installed.
Notes:
• "Primary" denotes the riser cage is installed in the primary riser connector.
• "Secondary" denotes the riser cage is installed in the secondary riser connector.
• Installing the riser cages listed in the table above in either the primary or secondary riser connectors
determines the form factor of the PCI cards supported by those riser cages.
• FL/FH denotes full-length, full-height. HL/FH denotes half-length, full-height. LP denotes low profile.
Device numbers
• 4LFF configuration
• 8SFF configuration
To Next Page
Loading...
