Hardware options installation 65
Connect the VGA/USB cable to the Front VGA/USB connector toward the rear of the system
board.
o 4 LFF optical drive connection
Connect the SATA optical cable to the SATA optical/storage drive connector.
8. Install the access panel (on page 22).
9. Slide the server into the rack.
10. Connect all power cords to the server, and then power up the server.
8SFF Universal Media Bay option
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before
beginning any installation procedure. Improper grounding can cause ESD.
To Next Page
Loading...
