Hardware options installation 56
3.
Install the drives.
4. Install an SFF drive blank in any unused drive bays.
CAUTION: Do not remove an NVMe SSD from the drive bay while the Do Not Remove
button LED is flashing. The Do Not Remove button LED flashes to indicate the device is still in
use. Removal of the NVMe SSD before the device has completed and ceased signal/traffic
flow can cause loss of data.
To remove the component:
1. Press the Power button.
The Do Not Remove button LED illuminates and flashes. Do not press the button while the LED is
illuminated.
2. When the Do Not Remove button LED is no longer flashing or illuminated, press the Do Not Remove
button to open the release lever.
To Next Page
Loading...
