HP Onboard Administrator errors 175
SysLog messages
These messages are sent to the Onboard Administrator System Log and can be viewed using the various
interfaces to the Onboard Administrator.
The types of system log messages are defined as follows:
• LOG_EMERG—system is unusable
• LOG_ALERT—action must be taken immediately
• LOG_CRIT—critical conditions
• LOG_ERR—error conditions
• LOG_WARNING—warning conditions
• LOG_NOTICE—normal but significant condition
• LOG_INFO—informational
Alertmail log messages
Log type: LOG_ERR, Failure type: SW
Alertmail: Calculated invalid enclosure count for topology event
Alertmail: Failed to get initial enclosure status
Alertmail: Failed to read cooling info
Alertmail: Failed to read enclosure info
Alertmail: Failed to read enclosure names
Alertmail: Failed to read enclosure status
Alertmail: Failed to read event from mgmt subsystem
Alertmail: Failed to read LCD status
Alertmail: Failed to read powersupply measurements
Alertmail: Failed to read rack topology information
Alertmail: Failed to read status of fan [value]
Alertmail: Failed to read status of Interconnect [value]
Alertmail: Failed to read status of powersupply [value]
Alertmail: Failed to read topology after event
Alertmail: Failed to register with mgmt
Alertmail: Failed to send AlertMail to [value]
Alertmail: Failed to start reboot notifier thread
Authentication and startup log messages
Log type: LOG_WARNING, Failure type: SW
sulogin: cannot open [value]
sulogin: No password file
To Next Page
Loading...
