HP Onboard Administrator errors 178
DHCP Monitor: Could not start DHCPD for IPv4. Error: [value]
DHCP Monitor: Could not start DHCPD for IPv6. Error: [value]
DHCP Monitor: Could not stop dhcpd for [value]
DHCP Monitor: DHCPD is not running. Restarting OA.
Log type: LOG_NOTICE, Failure type: SW
OA: Got IP lease: address = [address]
Log type: LOG_INFO, Failure type: SW
OA: infinite IP address lease time. Exiting
Enclosure-Link log messages
Log type: LOG_WARNING, Failure type: SW
OA: Enclosure Link Daemon could not register for events.
Log type: LOG_CRIT, Failure type: SW
Enclosure-Link: Could not acquire bottom enclosure's UUID. Cannot set RUID.
Enclosure-Link: Failed to read topology
Enclosure-Link: Got unexpected error from socket: [value]
Enclosure-Link: RUID recovered: [value]
Log type: LOG_ERR, Failure type: SW
Enclosure-Link: [value] enclosure(s) seen on Enclosure Link. Only
[value:Max_Enclosures] enclosure(s) supported. Please remove [value]
enclosure(s)
Enclosure-Link: Corrupted topology on eth2
Enclosure-Link: Corrupted topology on eth3
Enclosure-Link: Failed to create socket
Enclosure-Link: Failed to detect Enclosure topology
Enclosure-Link: Failed to disable lower chain
Enclosure-Link: Failed to disable upper chain
Enclosure-Link: Failed to enable lower chain
Enclosure-Link: Failed to enable upper chain
Enclosure-Link: Failed to generate EVENT for initial topology detection
Enclosure-Link: Failed to generate EVENT for topology change
Enclosure-Link: Failed to get local address. Will keep retrying
Enclosure-Link: Failed to log into enclosure [value:IpAddress]
Enclosure-Link: Failed to probe newly attached/detached device
Enclosure-Link: Failed to read events from chain
Enclosure-Link: Failed to register with enclosure [value:IpAddress]
Enclosure-Link: Failed to retrieve enclosure addresses from lower elink chain
Enclosure-Link: Failed to retrieve enclosure addresses from upper elink chain
Enclosure-Link: Failed to send ICMP packet to host
To Next Page
Loading...
