HP Onboard Administrator errors 203
OA: Authentication failure for user HP SSO [value]
OA: Authentication failure for user HP SSO [value] from [value:remoteAddress]
OA: HP SSO Trust Mode changed to [value] by user [value:username].
Two-factor log messages
Log type: LOG_WARNING, Failure type:SW
OA: Two Factor: Two-Factor authentication failed for user at [value]: local user
certificate status check failed.
Log type: LOG_WARNING, Failure type: Info
OA: Two Factor: [value:username] logged into the Onboard Administrator from
[value] using Two-Factor
OA: Two Factor: [value:username] logged into the Onboard Administrator from
Enclosure Link using Two-Factor
OA: Two Factor: Unable to create session for user [value:username]: the maximum
number of sesssions has been reached.
Log type: LOG_CRIT, Failure type: SW
OA: Two Factor: Two-Factor authentication failed for user at [value]: the
certificate provided could not be authenticated.
Log type: LOG_ERR, Failure type: SW
Two Factor: Error allocating memory.
Two Factor: Error creating place holder for CRL
Two Factor: Error creating temp store for CRL
Two Factor: Error downloading CRL from [value:URL]
Two Factor: Error mapping CRL files.
Two Factor: Error starting CRL service.
Two Factor: Insufficient privileges.
Two Factor: Internal error.
Two Factor: Invalid/corrupt CRL file at [value:URL]
Two Factor: Messaging system error.
FIPS log messages
Log type: LOG_INFO, Failure type: SW
FIPS: Onboard Administrator is operating in FIPS Mode Debug.
FIPS: Onboard Administrator is operating in FIPS Mode On.
FIPS: Too many Known Answer Test (KAT) failures: left FIPS mode
FIPS: "Last reboot was due to a Known Answer Test (KAT) failure.
Log type: LOG_ERR, Failure type: SW
OA: Error restoring factory default settings. Restoring FIPS mode...
OA: Failed to restore FIPS mode for standby Onboard Administrator.
To Next Page
Loading...
