HP ProLiant Gen9 - Linux Log Messages; Management Log Messages

HP Onboard Administrator errors 193
OA: Not possible to get the actual VC Mode of the enclosure.
Linux log messages
Log type: LOG_NOTICE, Failure type: Info
OA: Authentication failure for user [username] from [remote host] requesting
[value]
OA: Authentication failure for user [username] from Enclosure Link requesting
[value]
OA: Authentication failure for user [username] on [value].
OA: Authentication failure for user [username] on the OA KVM.
OA: Authentication failure for user [username] on the OA serial console.
OA: Authentication failure for user [username] requesting [value]
Management log messages
Log type: LOG_EMERG, Failure type: SW
OA: Internal System Firmware Error, Rebooting.
Log type: LOG_WARNING, Failure type: HW
OA: A port mismatch was found with server blade bay [value:bladeNumber] and
interconnect bay [value:slotNumber]
OA: Temperature of I/O module in slot [value:slotNumber] is at alert level
Log type: LOG_WARNING, Failure type: SW
OA: iLO in bay [value] has not responded to the previous [value:count] capping
requests from the Enclosure Dynamic Power Cap.
Log type: LOG_CRIT, Failure type: HW
OA Tray firmware upgrade failed.
OA: Blade in bay [value:bladeNumber] contains an unsupported #[value] mezz card.
OA: Enclosure Status changed from [N/A/Unknown/OK/Degraded/Failed] to
[N/A/Unknown/OK/Degraded/Failed].
OA: Failed to initialize key components. Please call support immediately.
OA: Fan [value] firmware upgrade failed.
OA: Interconnect [value:slotNumber] firmware upgrade failed.
OA: Interconnect [value] firmware upgrade failed.
OA: LCD fails to respond to keystrokes.
OA: LCD firmware upgrade failed.
OA: LCD not functioning properly, pausing operation for 10 seconds.
OA: LCD Status is: Failed
OA: mgmt: GPIO initialization failed.
OA: mgmt: i2c initialization failed.
OA: Mismatching I/O was detected on Blade [value:bladeNumber], interconnect
[value].