EasyManua.ls Logo

HP ProLiant Gen9 - Firmware Flash Log Messages

HP ProLiant Gen9
410 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
HP Onboard Administrator errors 181
Firmware flash log messages
Log type: LOG_ALERT, Failure type: SW
FWSync: OA firmware sync flash failed and system is in an unstable state. Do not
reboot! Try to flash again with a new image.
OA_Flash: Flash failed and system is in an unstable state. Do not reboot!Try to
flash again with a new image.
Log type: LOG_ERR, Failure type: SW
FWSync: Error opening OA firmware sync image.
FWSync: Error opening OA firmware sync image.
FWSync: Invalid flash image.
FWSync: OA firmware sync image is corrupted.
FWSync: OA firmware sync image is older than current firmware.
FWSync: Only one flash instance can run at a time.
FWSync: Only one instance of OA firmware sync can run at a time.
OA_Flash: Downloading flash image failed.
OA_Flash: Error opening [value] for input.
OA_Flash: Firmware image is corrupted or not a valid image. Please verify the
url and try again.
OA_Flash: Firmware version [value:version] is not supported on this hardware.
OA_Flash: Found core file. Reboot after flash suppressed to allow developer to
debug.
OA_Flash: Invalid flash image.
OA_Flash: Invalid flash image.
OA_Flash: Only one flash instance can run at a time.
OA_Flash: Out of memory while decoding flash image.
OA_Flash: The firmware image provided is older than the current firmware and OA
settings cannot be preserved. The force downgrade option must be used. Please
re-try with the force option to flash and go back to factory defaults.
Log type: LOG_NOTICE, Failure type: Info
FWSync: New firmware image flashed.
FWSync: OA firmware sync to [value:version] complete
OA_Flash: Firmware image flashed from [value:version] to [value:version]
Log type: LOG_INFO, Failure type: Info
OA_Flash: Image verified successfully and applies to this system using the
parameters supplied. Test Mode specified, skipping the actual flash process
Firmware version [value:version] ExitCode=0
Flash certificate, configuration, and storage log messages
Log type: LOG_ERR, Failure type: SW
CERTS: .ssh has wrong directory permissions

Table of Contents

Related product manuals