HP Onboard Administrator errors 180
envtools: Error in ipAllow5 address
envtools: Error in ipv6Dns1 address
envtools: Error in ipv6Dns2 address
envtools: Error in ipv6StaticAddress1 address
envtools: Error in ipv6StaticAddress2 address
envtools: Error in ipv6StaticAddress3 address
envtools: Error in netmask
envtools: Error: Administrator account was disabled and will be re-enabled upon
restart.
envtools: Error: Administrator account was missing, and will be re-created upon
restart. LPR required.
envtools: NVRAM write failed: [value]
DHCP Monitor: Error opening dhcpv6.conf for writing.
Log type: LOG_NOTICE, Failure type: SW
envtools: NVRAM block [value] failed check
envtools: NVRAM format could not be preserved.
envtools: NVRAM is unformatted or corrupted.
envtools: Warning: EBIPA has been disabled on device and interconnect bays. Please
check configuration after downgrade.
Log type: LOG_NOTICE, Failure type: Info
envtools: Downgrading NVRAM version from 24 to 23.
envtools: Downgrading NVRAM version from 25 to 24.
envtools: Downgrading NVRAM version from 26 to 25.
envtools: Downgrading NVRAM version from 27 to 26.
envtools: Factory Settings Restored.
envtools: NVRAM downgraded from [value] to [value].
envtools: NVRAM downgraded to version [value]
envtools: Updating NVRAM version to 19.
envtools: Updating NVRAM version to 20.
envtools: Updating NVRAM version to 21.
envtools: Updating NVRAM version to 22.
envtools: Updating NVRAM version to 23.
envtools: Updating NVRAM version to 24.
envtools: Updating NVRAM version to 25.
envtools: Updating NVRAM version to 26.
envtools: Updating NVRAM version to 27.
envtools: Updating NVRAM version to 28.
envtools: Updating NVRAM version to 29.
To Next Page
Loading...
