HP ProLiant Gen9 - Non-Volatile Configuration Log Messages

HP Onboard Administrator errors 179
Enclosure-Link: Failed to update hosts file
Enclosure-Link: Failed to write updated topology map
Enclosure-Link: Found 2 GuestPCs on Enclosure Link. This setup is not supported.
Enclosure-Link: Ignoring invalid Enclosure Link address
Enclosure-Link: Seeing heavy traffic on Enclosure Link chain. This may affect
topology.
Enclosure-Link: This can also occur if the enclosures have been connected in a
loop which is an unsupported configuration. Please make sure the top and bottom
enclosures are not connected to each other.
Log type: LOG_INFO, Failure type: Info
Enclosure-Link: Calling getEvent
Enclosure-Link: Device attached on lower interface
Enclosure-Link: Device attached on upper interface
Enclosure-Link: Device attached/detached but no topology changes detected
Enclosure-Link: Device detached on lower interface
Enclosure-Link: Device detached on upper interface
Enclosure-Link: Doing elink topology scan now
Enclosure-Link: Found new elink topology. Notifying subsystems
Enclosure-Link: Found new Topology: [value] enclosure added to chain ([value]
total)
Enclosure-Link: Found new Topology: [value] enclosure removed from chain ([value]
total)
Enclosure-Link: Found new Topology: New enclosure connected ([value] total)
Enclosure-Link: Got new TOPOLOGY event on enclosure [value:IpAddress]
Enclosure-Link: Initial topology scan completed successfully
Enclosure-Link: Service started
Non-volatile configuration log messages
Log type: LOG_WARNING, Failure type: SW
CLI: Error accessing User Configuration Files
Log type: LOG_ERR, Failure type: SW
envtools: Block [value] failed encoding
envtools: Error in default gateway
envtools: Error in DNS1 address
envtools: Error in DNS2 address
envtools: Error in ipaddress
envtools: Error in ipAllow1 address
envtools: Error in ipAllow2 address
envtools: Error in ipAllow3 address
envtools: Error in ipAllow4 address