Microsoft Windows Event ID and SNMP traps 274
Log Severity: Warning (2)
Log Message: The Threshold Agent could not set the variable because the value is invalid or out of range. The
data contains the error code.
Event identifier: cpqhsmsg.dll - 2359 (Hex)0x84350937 (Service Event)
Log Severity: Warning (2)
Log Message: The Threshold Agent is not loaded. Sets are not available. The data contains the error code.
Event Identifiers 3072-3876
Event identifier: cpqhsmsg.dll - 3072 (Hex)0x84350c00 (Service Event)
Log Severity: Warning (2)
Log Message: Could not read from the registry sub-key. This error can be caused by a corrupt registry or a
low memory condition. Rebooting the server may correct this error.
Event identifier: cpqhsmsg.dll - 3073 (Hex)0x84350c01 (Service Event)
Log Severity: Warning (2)
Log Message: Could not create the registry sub-key: “%1”. This error can be caused by a corrupt registry or
a low memory condition. Rebooting the server may correct this error.
Event identifier: cpqhsmsg.dll - 3074 (Hex)0x84350c02 (Service Event)
Log Severity: Warning (2)
Log Message: Could not create the registry sub-key: “%1”. This error can be caused by a corrupt registry or
a low memory condition. Rebooting the server may correct this error.
Event identifier: cpqhsmsg.dll - 3075 (Hex)0x84350c03 (Service Event)
Log Severity: Warning (2)
Log Message: Unable to read “%1” from the registry. This error can be caused by a corrupt registry or a low
memory condition. Rebooting the server may correct this error.
Event identifier: cpqhsmsg.dll - 3076 (Hex)0x84350c04 (Service Event)
Log Severity: Warning (2)
Log Message: Unable to read “%1” from the registry. This error can be caused by a corrupt registry or a low
memory condition. Rebooting the server may correct this error.
Event identifier: cpqhsmsg.dll - 3084 (Hex)0xc4350c0c (Service Event)
Log Severity: Error (3)
Log Message: Unable to read configuration (%1) from the registry. This error can be caused by a corrupt
registry, a low memory condition, or incomplete configuration. Reconfigure the Management Agents using
the control panel. Rebooting the server may also correct this error.
Event identifier: cpqhsmsg.dll - 3085 (Hex)0x84350c0d (Service Event)
Log Severity: Warning (2)
Log Message: Unable to write (%1) to the registry. This error can be caused by a corrupt registry or a low
memory condition. Rebooting the server may correct this error.
Event identifier: cpqhsmsg.dll - 3086 (Hex)0x84350c0e (Service Event)
To Next Page
Loading...
