EasyManua.ls Logo

HP ProLiant Gen9 - Operational Log Messages

HP ProLiant Gen9
410 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
HP Onboard Administrator errors 185
OA: Screenshot Thread exiting....
OA: KVM Bay [value:bladeNumber] - Could not determine fips mode
OA: KVM Bay [value:bladeNumber] - Configure ILO to enforce AES Encryption in FIPS
mode.
OA: KVM - Could determine OA fips mode
OA: KVM Bay [value:bladeNumber] - ILO2 is not supported in FIPS MODE.
Log type: LOG_ERR, Failure type: Info
OA: KVM ([value:address]) Change ILO setting to enable 'acquire remote console'
failed.
OA: KVM Bay [value:bladeNumber] - Acquired console. Connected to blade.
OA: KVM Bay [value:bladeNumber] - Connecting to blade failed because the blade
is powered off.
OA: KVM Bay [value:bladeNumber] - Connecting to blade.
OA: KVM Bay [value:bladeNumber] - Console in use by another client.
OA: KVM Bay [value:bladeNumber] - Console is in use by another client and could
not be acquired.
OA: KVM Bay [value:bladeNumber] - Console session acquired by [value:OA user /
username] at [value:address]
OA: KVM Bay [value:bladeNumber] - Disconnected from blade due to app exit.
OA: KVM Bay [value:bladeNumber] - Disconnected from blade.
OA: KVM Bay [value:bladeNumber] - Must wait 5 minutes before attempting to acquire
the console.
OA: KVM Bay [value:bladeNumber] - Session acquired by different user.
OA: KVM Blade [value:bladeNumber] console session closed due to ILO firmware
upgrade
Operational log messages
Log type: LOG_EMERG, Failure type: SW
OA: Internal System Firmware Error. Rebooting.
Log type: LOG_WARNING, Failure type: SW
FWSync: OA firmware sync failed to create firmware image from the Active Onboard
Administrator
FWSync: OA firmware sync failed to create firmware image from the Standby Onboard
Administrator
FWSync: OA firmware sync of the Active Onboard Administrator failed
FWSync: OA firmware sync of the Standby Onboard Administrator failed
OA: Active Onboard Administrator will not be flashed
OA: Consider resetting the Standby and/or Active Onboard Administrators and
retrying
OA: Failed flashing Standby Onboard Administrator
OA: Failed to copy firmware image to the Standby Onboard Administrator

Table of Contents

Related product manuals