HP Virtual Connect errors 229
Description: A profile was changed or assigned and some configuration required that the server be powered
off to make the change. For example, if the number of Ethernet connections is changed for a profile that is
assigned to a server with Flex-10 NICs, then the server must be powered off.
Possible causes:
• A user action results in a profile that requires the server be powered off to make the change or initially
assign or remove the profile.
• VCM restarts and detects a powered on server that has a profile assigned to the bay and the profile
needs to make a change on the server that requires it to be powered off.
Action: Power down the server and retry the change.
Ethernet Network events (7000-7999)
7012 - Enet Network state FAILED
Severity: CRITICAL
Description: The VC Enet Network lost all uplink connectivity because of lack of configured ports or all
configured ports are in a bad state or because a bad or incompatible transceiver was inserted.
Possible causes:
• All of the uplink ports associated with the network are unlinked.
• The user disables all the uplink ports associated with a non-shared network.
• The user disables all the uplink ports in a shared uplink set associated with a shared network.
Action:
• Connect the uplink ports.
• Enable the uplink ports associated with a non-shared network.
• Enable the uplink ports in a shared uplink set associated with a shared network.
7014 - Enet Network state DISABLED
Severity: MAJOR
Description: A network has been administratively disabled.
Possible cause: A user disabled a network through the UI.
Action: Enable the network through the UI.
FC Fabric events (8000-8999)
8012 - FC Fabric state FAILED
Severity: CRITICAL
Description: The VC fabric lost all uplink connectivity because of lack of configured ports or all configured
ports are in a bad state.
Possible causes:
To Next Page
Loading...
