HP ProLiant Gen9 - Page 199

HP Onboard Administrator errors 199
OA: Redundant Onboard Administrator was inserted
OA: Server Power Reduction - Activated
OA: Server Power Reduction Mode - Disabled
OA: Server Power Reduction Mode - Enabled
OA: Server Power Reduction Mode - Enabled
OA: TRAY microcode updated from UNKNOWN version to version [value:version]
OA: TRAY microcode updated from version [value:version] to version
[value:version]
Log type: LOG_INFO, Failure type: HW
OA: Interconnect removed from bay [value:slotNumber]
Log type: LOG_INFO, Failure type: SW
OA: A USB Key was inserted into the Onboard Administrator.
OA: A USB Key was removed from the Onboard Administrator.
OA: A CD-ROM Drive was inserted into the Onboard Administrator.
OA: Media was removed from CD-ROM Drive.
OA: CD-ROM Drive has no media.
OA: Media in CD-ROM Drive detected. Volume Label: [value]
OA: Blade [value:bladeNumber]: Mezz card internal data problem for [value].
OA: Failed to mount [CD/DVD/USB Key]: [value:errorCode]
OA: Failed to mount [CD/DVD/USB Key][value]: unsupported filesystem.
OA: Interconnect inserted in bay [value:slotNumber]
OA: VC module in interconnect bay [value:slotNumber] has firmware revision
[value:version] but minimum firmware revision [value:version] is required
Log type: LOG_INFO, Failure type: Info
OA Tray firmware upgrade initiated.
OA Tray firmware upgrade succeeded.
OA: Blade [value:bladeNumber] management processor firmware upgrade initiated.
OA: Blade [value:bladeNumber] management processor firmware upgrade succeeded.
OA: Fan [value] firmware upgrade initiated.
OA: Fan [value] firmware upgrade succeeded.
OA: Interconnect [value:slotNumber] firmware upgrade initiated.
OA: Interconnect [value:slotNumber] firmware upgrade succeeded.
OA: Interconnect [value] firmware upgrade initiated.
OA: Interconnect [value] firmware upgrade succeeded.
OA: Interconnect module in bay [value:slotNumber] was powered off
OA: Interconnect module in bay [value:slotNumber] was powered on
OA: LCD firmware upgrade initiated.
OA: LCD firmware upgrade succeeded.
OA: Server Blade in bay [value:bladeNumber] has been powered down