Microsoft Windows Event ID and SNMP traps 280
Log Message: The External Status MIB Agent is not loaded. Sets are not available. The data contains the error
code.
Event identifier: cpqhsmsg.dll - 4608 (Hex)0x84351200 (Service Event)
Log Severity: Warning (2)
Log Message: Unable to allocate memory. This indicates a low memory condition. Rebooting the system will
correct this error.
Event identifier: cpqhsmsg.dll - 4609 (Hex)0x84351201 (Service Event)
Log Severity: Warning (2)
Log Message: Could not read from the registry sub-key. This error can be caused by a corrupt registry or a
low memory condition. Rebooting the server may correct this error.
Event identifier: cpqhsmsg.dll - 4610 (Hex)0x84351202 (Service Event)
Log Severity: Warning (2)
Log Message: Could not write the registry sub-key: “%1”. This error can be caused by a corrupt registry or
a low memory condition. Rebooting the server may correct this error.
Event identifier: cpqhsmsg.dll - 4611 (Hex)0x84351203 (Service Event)
Log Severity: Warning (2)
Log Message: Could not read the registry sub-key: “%1”. This error can be caused by a corrupt registry or
a low memory condition. Rebooting the server may correct this error.
Event identifier: cpqhsmsg.dll - 4612 (Hex)0x84351204 (Service Event)
Log Severity: Warning (2)
Log Message: Could not read from the registry sub-key: “%1”. This error can be caused by a corrupt registry
or a low memory condition. Rebooting the server may correct this error.
Event identifier: cpqhsmsg.dll - 4613 (Hex)0x84351205 (Service Event)
Log Severity: Warning (2)
Log Message: Could not read from the registry sub-key: “%1”. This error can be caused by a corrupt registry
or a low memory condition. Rebooting the server may correct this error.
Event identifier: cpqhsmsg.dll - 4623 (Hex)0x8435120f (Service Event)
Log Severity: Warning (2)
Log Message: The Agent could not access WMI. The WMI support may have not been started or installed.
Restart or Install WMI service and restart the agents.
Event identifier: cpqhsmsg.dll - 4624 (Hex)0x84351210 (Service Event)
Log Severity: Warning (2)
Log Message: The Agent requires WMI service to be running. If NT 4.0 installed the latest version of WMI
from Microsoft®, WMI service may need to be started.
Event identifier: cpqhsmsg.dll - 4625 (Hex)0x84351211 (Service Event)
Log Severity: Warning (2)
Log Message: The Agent failed to initialize WMI. WMI service may not have started or may still be in the
starting state.
To Next Page
Loading...
