HP ProLiant Gen9 - Page 384

Microsoft Windows Event ID and SNMP traps 384
Symptom: The Management processor is ready. The management processor has successfully reset and is
now available again.
User action: None
Supporting SNMP Trap Data:
• sysName
• cpqHoTrapFlags
Supporting SNMP Trap Description: “The Management processor is ready after a successfull reset”
NT Event ID: 1181 (Hex) 0x8435049D (cpqsvmsg.dll)
Log Severity: Warning (3)
Log Message: The Management Processor has not reset successfully and is not operational. The data
contains the error code.
SNMP Trap: cpqHeManagementProcFailedReset - 6063 in CPQHLTH.MIB
Symptom: The Management processor failed reset. The management processor was not successfully reset
and is not operational.
User action: Reset the management procesessor again or re-flash the management processor firmware.
Supporting SNMP Trap Data:
• sysName
• cpqHoTrapFlags
Supporting SNMP Trap Description: The Management processor failed reset.
NT Event ID: 1182 (Hex)0x4435049EL
Log Severity: Informational
Log Message: USB storage device '%5' attached. The data contains the error code.
SNMP Trap: 1008 in CPQSTDEQ.MIB
Symptom: The USB key is attached to the server.
User Action: None required.
Supporting SNMP Trap Data:
• sysName,
• cpqHoTrapFlags
• cpqSeUSBDeviceType
• cpqSeUSBDeviceName
Supporting SNMP Trap Description: This trap is sent when a USB storage device has been attached.
Symbolic Name: CPQ_STD_USB_DEV_ATTACHED
NT Event ID: 1183 (Hex)0x4435049FL
Log Severity: Informational
Log Message: USB storage device '%5' removed. The data contains the error code.
SNMP TRAP: 1009 in CPQSTDEQ.MIB