HP ProLiant Gen9 - Page 392

Microsoft Windows Event ID and SNMP traps 392
Log Message: The NIC Management Agent could not set an event. The data contain the error code.
Event identifier: cpqnimsg.dll - 280 (Hex)0x84350118 (Service Event)
Log Severity: Warning (2)
Log Message: The NIC Management Agent service could not start any agents successfully.
Event identifier: cpqnimsg.dll - 281 (Hex)0x84350119 (Service Event)
Log Severity: Warning (2)
Log Message: The NIC Management Agent main thread did not terminate properly. The data contain the
error code.
Event identifier: cpqnimsg.dll - 283 (Hex)0x8435011b (Service Event)
Log Severity: Warning (2)
Log Message: The NIC Management Agent did not respond to a request. The data contain the error code.
Event identifier: cpqnimsg.dll - 285 (Hex)0x8435011d (Service Event)
Log Severity: Warning (2)
Log Message: The NIC Management Agent could not get the system type. The data contain the error code.
Event identifier: cpqnimsg.dll - 287 (Hex)0x8435011f (Service Event)
Log Severity: Warning (2)
Log Message: The NIC Agent service could not load the module “%1”. The data contain the error code.
Event identifier: cpqnimsg.dll - 288 (Hex)0x84350120 (Service Event)
Log Severity: Warning (2)
Log Message: The NIC Agent service could get the control function for module “%1”. The data contain the
error code.
Event identifier: cpqnimsg.dll - 290 (Hex)0x84350122 (Service Event)
Log Severity: Warning (2)
Log Message: The NIC Agent service could not start agent “%1”. The data contain the error code.
Event identifier: cpqnimsg.dll - 291 (Hex)0x84350123 (Service Event)
Log Severity: Warning (2)
Log Message: The NIC Agent service detected an invalid state for agent *”%1”. The data contain the state.
Event identifier: cpqnimsg.dll - 292 (Hex)0x84350124 (Service Event)
Log Severity: Warning (2)
Log Message: The NIC Agent service could not stop agent “%1”. The data contain the error code.
Event identifier: cpqnimsg.dll - 293 (Hex)0x84350125 (Service Event)
Log Severity: Warning (2)
Log Message: The NIC Agent service could not terminate agent “%1”. The data contain the error code.
Event identifier: cpqnimsg.dll - 294 (Hex)0x84350126 (Service Event)
Log Severity: Warning (2)
Log Message: The NIC Agent service could not unload the module “%1”. The data contain the error code.