HP ProLiant Gen9 - Page 78

HP ProLiant server errors 78
1742-Slot X Drive Array - Previously Ejected Drive(s) Detected...
The logical drive(s) will remain unavailable until re-enabled by the Array Configuration Utility. Port x Box y Bay(s) z.
Possible cause: The system detects that the drives are still present during POST and that the user previously
requested the drives to be removed from the controller configuration information.
Action: Do one of the following:
• If the drives will be removed at a later time, to continue ignoring the physical drives, press F1.
• To cancel the remove request and add these physical and logical drives back to the controller, press F2.
• To re-enable the drives, use HP SSA.
1743-Slot X Drive Array - Logical Drive Erase Operation in Progress...
...Logical drives being erased are temporarily offline.
Audible Beeps: None
Possible Cause: The drives being erased are offline.
Action: Do one of the following:
• Wait for the erase process to complete before using the logical drive.
• Abort the erase process using ACU.
1743-Slot X Drive Array - Logical Drive Erase Operation(s) are Queued...
...Logical drives will temporarily go offline while being erased.
Audible Beeps: None
Possible Cause: The drives being erased are offline.
Action: Do one of the following:
• Wait for the erase process to complete before using the logical drive.
• Abort the erase process using ACU.
1744-Slot X Drive Array - Drive Erase Operation In Progress (or Queued)...
...The following disk drive(s) will be blank upon completion: (followed by a list of drives)
Audible Beeps: None
Possible Cause: A drive erase operation was previously initiated by the user and is in progress or is
scheduled for all drives in the list.
Action: None required
1745-Slot X Drive Array - Drive Erase Operation Completed...
...The following disk drive(s) have been erased and will remain offline until hot-replaced or re-enabled by the Array
Configuration Utility:
(followed by a list of drives)