Installing Hardware Options
HP ProLiant ML370 Generation 3 Server Setup and Installation Guide 3-59
HP CONFIDENTIAL
Writer: Jennifer Hayward File Name: d-ch03 Installing Hardware Options.doc
Codename: Dizzy Devil Part Number: 281992-002 Last Saved On: 12/3/02 12:45 PM
7. Connect the SCSI and power cables:
a. Connect the SCSI cable that comes with the SCSI drive cage option kit to the
SCSI connector on the back of the SCSI drive cage (1).
b. Connect the other end of the SCSI cable to one of the internal SCSI
connectors on the system board (2).
c. Locate the power cable inside the server and connect the power cable to the
power connector on the SCSI drive cage (3).
Figure 3-49: Connecting the SCSI and power cables
8. Reinstall the following items:
— CD-ROM drive, if needed
— Center wall
— Expansion boards
— Processor air baffle
Refer to the HP Internal Two-Bay Hot-Plug SCSI Drive Cage Installation
Instructions for additional information.
To Next Page
Loading...
