LED Indicators and Switches
E-18 HP ProLiant ML370 Generation 3 Server Setup and Installation Guide
HP CONFIDENTIAL
Writer: Jennifer Hayward File Name: m-appe LED Indicators and Switches.doc
Codename: Dizzy Devil Part Number: 281992-002 Last Saved On: 12/3/02 2:48 PM
3. Set the position 6 lever to the On position.
4. Power up the server.
All configuration settings are now erased and all system operations halt.
5. Power down the server.
6. Reset the position 6 lever to the default Off position.
7. Power up the server.
8. Press the F9 key to run RBSU and reset all system configuration settings.
NOTE: For instructions on using RBSU to reset system configuration settings, refer to
Chapter 7, “Server Configuration and Utilities.”
ROMPaq Disaster Recovery Mode
A corrupted system ROM requires that you recreate the ROM BIOS by a process
called flashing the ROM. This operation can be accomplished only when the system
is in disaster recovery (emergency repair boot) mode. When both system ROMs are
corrupt, the system defaults into disaster recovery mode automatically. Proceed by
following the instructions displayed on a monitor or event log.
IMPORTANT: Before performing this operation, refer to the Servers Troubleshooting Guide
for complete instructions on disaster recovery.
To Next Page
Loading...
