Installing the Rack Server
HP ProLiant ML370 Generation 3 Server Setup and Installation Guide 4-25
HP CONFIDENTIAL
Writer: Jennifer Hayward File Name: e-ch04 Installing the Rack Server.doc
Codename: Dizzy Devil Part Number: 281992-002 Last Saved On: 12/3/02 2:12 PM
Figure 4-20 shows the cable management arm fully open, enabling access to the
server rear panel.
Figure 4-20: Cable management arm fully open
Rack Options
In addition to the rack kit provided with the server, there are rack option kits
available that enable you to install the server into a Telco or any round-hole rack.
Telco Rack Option
The Telco rack adapter kit includes rack rails, installation hardware, and instructions
for installing a server into a Telco rack. For information about obtaining an optional
Telco rack adapter kit, contact your authorized reseller or refer to
www.hp.com/products/servers/platforms
WARNING: When installing the server in a Telco rack, be sure that the rack
frame is adequately secured to the top and bottom of the building structure.
To Next Page
Loading...
